First off, I do not know this seller, this is my honest review of the product from a customer.
The shipping was fast, but I am in San Jose, CA and the item was shipped from Oakland, CA which is only a short drive from me.
Here are some pics of the uppipe fresh out of the box:



It looks a little bit like the helix flex pipe but not as clean.
Weld quality looks decent, but I would like to have seen welds on the inside of the pipe
at the flange.
This picture shows what I am talking about:


Sorry I don't have install pics, but that part is pretty well covered on forums, take out the
intercooler, airbox, plastic skid plate, heat shields, passenger side header, down pipe, engine mount bolt
(need an impact wrench for that one), jack up the engine 2 inches, pull out the stock uppipe, etc...

So as we are putting everything back together, we get to the downpipe and come to find out that 2 of the
flange bolts are TOO LONG! and the bottom 2 bolts of the DP side of the turbo are blocked by 2 of the
uppipe bolts!

CRAPPY!

So now we have to unbolt the header again, then the uppipe, rework the PIA of fitting the uppipe with the
EGT sensor still in tact, cut off the tips of these 2 bolts:


So we dremel off the tips of the two bolts(went through a couple dremel bits for this since its super strong steel)
then put everything back together.

I used the two gaskets provided, re-used the 2 factory header bolts instead of the 2 it came with.
No exhaust leaks! YAY! :D

I have much, much better low end power now, turbo spool up is a lot better then stock.
So far I have put over 3000 miles on this uppipe and had ZERO problems.

The seller does not have very good communication skills though, product is good, should have included
instructions and should know about the flange bolt problem. I e-mailed asking for a little reimbursment for
my wasted install time by giving me a deal on the $17 rear strut bar, but never got a reply.
If you want to buy from this seller, make sure you are not in a rush, and don't expect too good of
customer service.
This review is on the PRODUCT, not the seller cause I don't know who s/he is.
please feel free to contact me with questions about this product at mattsnow@gmail.com.
--Matt